GE Healthcare · MRSignaExcite
Intercom Squeal Caused by Changes to Audio Driver Codes in 15.0 Software.
Symptom
Intercom Noise Producing High Pitch Whining or Squeal Out of the Patient Speaker. IF you see this on an HDxT system, write a Trackwise report. IF you see this on an HDxT system, write a Trackwise report.. The intercom produced a whine at the patient speaker. Replacing the WIM, SCIM, Remote Intercom board (rear pedestal) and associated cables did not fix the problem. We even tried laying out a new set of hardware on the floor outside of the screen room, which bypassed the Pen panel filter. We still had the whining speaker.
Applies to
- Models
- Signa, Excite
- Product
- Signa HDxT This product is for 1.5T Signa HDxT systems with 15.0 software and HDi systems with 15.0 software. This product is for 1.5T Signa HDxT systems with 15.0 software and HDi systems with 15.0 software.
- Software
- 15.0 For Product Signa HDxT and HDi only. -- NOT to be used with HDe. -- For Product Signa HDxT and HDi only. -- NOT to be used with HDe. --
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- Unable to Load Applications Software during restoreinfo Due to Corrupt saveinfo Disk.