GE Healthcare · MR
What is the TCU2 Temperature Controller Unit II Setup and Calibration.
Symptom
What is the TCU2 Temperature Controller Unit II Setup and Calibration See Long Description What is the TCU2 (Temperature Controller Unit II) Setup and Calibration? We are looking for some documentation on how to set up the TCU and could not find any, other than sensor and heater troubleshooting and replacement in the magnet manual. Do these TCUs arrive preset to 28 C or do they require some set up at install? If they do require set up, where can an FE find documentation on how to do this?
Applies to
- Product
- Open Speed with EXCITE For HFO4 and HFO5 only
- Software
- OPENMR5-HFO5 Open Speed with Excite Product
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.