GE Healthcare · MRExcite
What are the Jumper Settings for the HDe PDU Control Board.
Symptom
What are the Jumper Settings for the HDe PDU Control Board? See Long Description What should JP1, JP4, JP5, and JP6 be set to on the HDe PDU Control board? Service Methods only shows JP2 & JP3. An FE received a FRU (same as board being replaced, not a new rev.) with different jumper settings for JP1,4,5,6 than what he saw on the original part. There is no direction as to what they should be. Since the jumper positions were not the same between the two boards, clarification was needed. Authore Paul Lyman Mar.26, 2009
Applies to
- Models
- Excite
- Product
- Excite HDe. For Hino HDe 14.0 and HDe 15.0 Software Systems only
- Software
- HDe 14.0 For Hino Excite HDe 14.0 systems only.
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- Unable to Load Applications Software during restoreinfo Due to Corrupt saveinfo Disk.
- CWA ID100315. Auto and Manual Prescan Fails.
- Ghosted or Smeared Head Images Using Head Coil due to Head TR Assembly.
- A Copper Coolant Line or Pipe Internal to the MCS Cabinet Chiller Burst due to Water Remaining in Unit Freezing During Shipment.