Unable to Run ECMT2 (Eddy Current Measurement Tool 2) due to ECMT2 Tool Hardware Kit.
Symptom
Unable to Run ECMT2 (Eddy Current Measurement Tool 2) See Long Description FE is unable to run ECMT2 (Eddy Current Measurement Tool 2). When he plugs in the ECMT2 kit's "Mouse house Service Interface tool" into the MSHS and downloads the scan prescription an error message pops up which is not logged, which reads as follows: "Prescribed coil and connected coil do not match", and the coilid MSHS (Mouse house) LED is red and never turns green. The system will let him prescan however, but there is no signal. FE is not sure whether the error message and red LED are normal or not when running this procedure so he is not sure how to troubleshoot. Should he work on the "no signal" problem, or on the coil recognition problem first?
Error message
Prescribed Coil and Connected Coil Do Not Match See Long Description "Prescribed coil and connected coil do not match". This is a popup message that does not appear in the message log.
Applies to
- Product
- Open Speed with EXCITE For HFO4 and HFO5 only
- Software
- OPENMR4-HFO4 Software version for HFO4 system, which is OpenSpeed with Excite Technology
- Component
- 2309800 ECMT2 Tool Hardware Kit 2309800 ECMT2 Tool Hardware Kit.
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.