GE Healthcare · MR
Cradle doesn't move to Isocenter accurately.
Symptom
Cradle doesn't move to Isocenter accurately Slice position is not where prescribed. Z-isocenter calibration is difficult to achieve due to moving the cradle after every adjustment.
Error message
-06- Error Displayed on the Magnet Display. Cradle accuracy slippage This error is not recorded in the system log, only displayed on the Magnet Display.
Applies to
- Product
- Profile 4
- Software
- 7.8x Profile4 or ProfileHSR only
- Component
- U0120AP Cradle Encoder Axis Jointer Coupler See Resolution concept for replacement procedure
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.