X100, MIS 28258A UPS Interface box to PDB TB1 Mislabeled for a X100 system
Symptom
X100, MIS 28258A UPS Interface box to PDB TB1 Mislabeled for a X100 system MIS 28258A UPS Interface box to PDB TB1 Mislabeled. Current MIS Chart in ASM (5160408-8 or 9-2EN rev1)shows PDB TB1 Wiring to be TB1 36, 37,38,39. The cable is labeled incorrectly and the Job card IST0065 section 4.3 shows the same incorrect info. The Correct wiring can be found on a older ASM 5160408-6-200. This ASM shows 39(Blk), 40(Grn), 41(Wht), 42(Red). MIS 28258A UPS Interface box to PDB TB1 Mislabeled. Current MIS Chart in ASM (5160408-9-2EN rev1)shows PDB TB1 Wiring to be TB1 36, 37,38,39. The cable is labeled incorrectly and the Job card IST0065 section 4.3 shows the same incorrect info. The Correct wiring can be found on a older ASM 5160408-6-200. This ASM shows 39(Blk), 40(Grn), 41(Wht), 42(Red).
Applies to
- Models
- Innova
- Product
- Innova X100 Monoplane Innova X100 Monoplane from product name Innova 2100, 3100 and 4100 Innova X100 Monoplane Innova 2100, 3100 and 4100 Innova X1 X1 Biplane Innova X1 X1 Bi-plane Innova 2121 or 3131 Bi-plane System Innova X1 X1 Bi-plane Innova 2121 or 3131 Bi-plane System
- Component
- SG-20 KVA UPS SG-20 KVA UPS Seelong. SG-20 KVA UPS OPM_SGS_USM_10K_40K_0US_V010.pdf 5380482 UL PDB Phase Control Relay LS1
- Area
- X-ray Vascular
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray Vascular issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray Vascular issues
- The Worklist does not refresh on the system when performing a query.
- Innova System boot failure
- INX1X; Message Limit switch engaged; LP4 Lateral Detector lift will not move after going to max SID using the Emergency Backout button on the lift cover because the lift hit maximum (Max) SID limit sw…
- Firewall is broadcasting DHCP addresses
- Cooling Failure; Shut System down and call Service is displayed on the Innova Image monitor
- No gantry motion is reported by the customer.