GE Healthcare · MR
OrthoMRI Coil base wires are broken.
Symptom
OrthoMRI Getting signal saturation error
Error message
OrthoMRI 1-46 Signal Saturation Do you want to proceed? Try to perform these steps in this order: check the Magnet Temperature, check Magnet Heaters and Sensors resistor values, change TMP and or MTCM. Typical issue is the software not at 9.1b or higher revision or the patient's skin is touching the coil. Foam padding is needed to isolate the patient from the coil.
Applies to
- Product
- OrthoMRI Cscan
- Software
- OrthoMRI S/W Release 9.1B. OrthoMRI S/W Release 9.1B.
- Component
- OrthoMRI LNR9102001000 WIRING BASE 6
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.