GE Healthcare · MRExcite225428050573

Unable to Perform Head Output Power Calibration due to Head Power Monitor Faults due to RF Coupler Element Not Seated Pr…

Unable to Perform Head Output Power Calibration due to Head Power Monitor Faults due to RF Coupler Element Not Seated Properly when Calibrating Head Output Power.

Symptom

Unable to Perform Head Output Power Calibration and UPM Head Calibration due to Head Power Monitor Faults. See Long Description Unable to perform head output power calibration and UPM head calibration due to head power monitor faults. Error: 2254280 Function: RF: RF Transmit PSD: cal Coil: HEAD Scan: 50573/1 3T RF Amplifier Forward Power High (fault 95). Possible Causes: PSD operating outside of safe region, incorrect values in MR config file. Modify PSD parameters, verify amp calibration factors. If the fault persists, replace the RF amplifier.->

Error message

2254280 3T RF Amplifier Forward Power High (fault 95). Head fault See Long Description Error: 2254280 Function: RF: RF Transmit PSD: cal Coil: HEAD Scan: 50573/1 3T RF Amplifier Forward Power High (fault 95). Possible Causes: PSD operating outside of safe region, incorrect values in MR config file. Modify PSD parameters, verify amp calibration factors. If the fault persists, replace the RF amplifier.->

Applies to

Models
Excite
Product
3T Excite HDx 14.0 Software. The software that this solution is tied to is indicated by the Software concept below.
Software
14.0 M5 Excite HDx HDi Platforms only.
Area
MR

Full cause & step-by-step resolution

The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.

Start free trialSign in

7-day free trial · no credit card required

Related GE Healthcare MR issues