GE Healthcare · MR
Magnet Monitor Device has created multiple alarms for one single parameter.
Symptom
Magnet Monitor Device has created multiple alarms for one single parameter Magnet Monitor device created more than 20 alarms for the same parameter in the last 12 hours and it is not known how to stop it from creating any more.
Applies to
- Product
- Magnet Monitor 3. Magnet Monitor 3 Magnet Monitor 3
- Software
- Magnet Monitor 3 revision 1.54. Magnet Monitor 3 revision 1.54, see long description for major fixes associated to this software version. Here is a list of the major changes associated with the version 1.54 MM3 release. Rev 1.54 If the Questra service agent shuts itself down for any reason, the main program will restart it one hour later. This just effects intentional shutdowns, there are no changes to the code that deals with QSA crashes and hung conditions. The 7T_2CH magnet type has new default config values than what was released in 1.53. The new 7T_2CH config files are already loaded at one of the 7T sites. (without changing the existing program code running there.) The "magmon booting" message in the event log now included the sw version string. Handy for figuring out what was running historically. There is a Run Time counter available on the LCD that shows how long the MM3's been running.
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.