What is Agfa CT error code HC11328?

MDM calibration missing for the film type in the middle tray. It is reported by the Film Tray Module on DryStar 5500 (Type 5364/100) and DryStar 5503 (Type 5364/300) CT systems. Severity: Alarm; subsystem: Film Tray Module — MDM Calibration.

What should a field engineer do about HC11328?

Run an MDM calibration for the film loaded in the middle tray.. Isolate the Film Tray Module — MDM Calibration subsystem and follow the status-code troubleshooting in the service manual. FSELIB documents the full diagnosis and remedy for the DryStar 5500 (Type 5364/100) / DryStar 5503 (Type 5364/300).

AlarmFilm Tray Module — MDM Calibration

HC11328 — MDM calibration missing for the film type in the middle tray

Agfa CT error code, reported by the Film Tray Module.

What HC11328 means

On DryStar 5500 (Type 5364/100) and DryStar 5503 (Type 5364/300) CT systems, status code HC11328 indicates: MDM calibration missing for the film type in the middle tray. The code originates in the Film Tray Module — MDM Calibration section of the Film Tray Module. Severity level alarm (Alarm).

Reported action: Run an MDM calibration for the film loaded in the middle tray..

Raised on the Drystar 5500/5503 (three-tray configurations) when no MDM (macrodensitometer) calibration is on file for the film type loaded in the middle tray. The printer shows "MDM calib. middle tray needed".

Full troubleshooting for HC11328

The complete diagnosis, cause tree, and step-by-step remedy for the Film Tray Module — MDM Calibration subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.

Open the Activion16 service manual

Related Film Tray Module — MDM Calibration codes

HC11326MDM calibration missing for the film type in the upper tray HC11327MDM calibration missing for the film type in the lower tray HC10053Themis board CPU too hot HC10100MEC PCB test failed HC10814Drum passed sensor S24 not connected or malfunctioning HC10815Drum entry sensor S23 not connected or malfunctioning HC11000Firewire cable between Crius and Themis boards not connected or faulty HC1100124V actuator power not available on the MEC board

Discuss HC11328 with other field engineers in the FSELIB forum

Source: AGFA DryStar service manual — HC error catalogue (FSELIB authored corpus). Reference information re-authored by FSELIB — not a copy of the OEM manual.