GE Healthcare · Nuclear MedicineMillennium
No Roll or Radial motion on MG, MC, or Myosight Gantry
Symptom
No Roll or Radial motion on MG, MC, or Myosight Gantry No Roll or Radial motion on MG, MC, or Myosight Gantry. Nor any LEDS (IN4, IN6, IN8, IN15, or IN16) lit up on Controller
Error message
Roll not in Position Roll not in Position. Error entry from errorlog when system boots into AUI. With a broken VG lock ground or RTN line, the controller will not see any of the Vg lock switches. Thus the error, "Roll not in Position".
Applies to
- Models
- Millennium
- Product
- MG/MC/Myosight Millennium MG/MC Millennium MyoSIGHT
- Component
- *Gantry Gantry Gantry
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Need part numbers for the Millennium MG/MC table E-Stop
- How do I Delete a file on Genieacq that the system thinks is still acquiring
- VG, the contour works... but in the opposite way.
- MG_MC_MyoSight_MPR_MPS Bar Phantom Resolution Size