GE Healthcare · Nuclear Medicine
IBXACQ system PMTUNE 4th or 5th iteration lasted over 2 minutes while it attempted to adjust the LED Rec.
Symptom
IBXACQ system PMTUNE 4th or 5th iteration lasted over 2 minutes while it attempted to adjust the LED Rec. PMTUNE program failed with message saying "Setup can not be completed for this scan" When LED Rec. adjustment was done manually from the Service menu it would display the same message (Curve is too low) but the adjustment would actually complete correctly and the E signal in the IB Box would look normal. However, it would still fail during Pmtune Update. Contributor 212002357 Nielsen March 12 2008
Error message
LED recovery failed - 6 retries. Curve is too low. Error message in the error log (listerr): "LED recovery failed - 6 retries. Curve is too low." Followed by some messages indicating the scan failed.
Applies to
- Product
- IBACQ/X IBACQ/X IBACQ/X
- Component
- *Detector (Imaging Detector) *Detector (Imaging Detector) *Detector (Imaging Detector)
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Need part numbers for the Millennium MG/MC table E-Stop