GE Healthcare · Nuclear MedicineMillennium
New feature on Genieacq 4.5 systems with EDI hardware,user notified if ECG signal is lost during acquisition.
Symptom
New feature on Genieacq 4.5 systems with EDI hardware,user notified if ECG signal is lost during acquisition. New feature on Genieacq 4.5 systems with EDI hardware, user notified if ECG signal is lost during acquisition. Customer has two Millennium MG systems and noticed that on one system the user would get an alert message when lost the ECG signal but not on the other system. Wanted to know how to enable this feature on the other system. Feature only available on Genieacq 4.5 systems with EDI hardware
Applies to
- Models
- Millennium
- Product
- MG/MC/Myosight Millennium MG/MC Millennium MyoSIGHT MPR/MPS Millennium MPR Millennium MPS
- Software
- GenieAcq R4.5 V14 (M4) Genieacq 4.5 Build 14 (M4) 5220379 Genieacq SW R4.5 V014 M4 with accumulative patches GA450-05-1, GA450-6-1, GA450-07-0, GA450-08-1, and GA450-09-0 for Spare Part GENIE Acq R 4.5 V014 supports EDI and I/N board hardware configurations. The following computer platforms are supported by this version: SuperMicro P4SBR ( only supports the EDI detctor, reference SN43628 ) IBM x205 Dell 1400SC Dell GX200 Dell 1300. Dell 2200 and Intel AltServer are not supported. Reference CIS 5150522-100_r2
- Component
- *Software Software Software *Application Protocol Application - Acquiring and Processing Application Protocol - Acquiring and Processing
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Need part numbers for the Millennium MG/MC table E-Stop
- How do I Delete a file on Genieacq that the system thinks is still acquiring
- VG, the contour works... but in the opposite way.
- MG_MC_MyoSight_MPR_MPS Bar Phantom Resolution Size