GE Healthcare · MRSigna2248602
Cable Connection at the Workspace Interface Module J6 Had Fallen Off While Mobile In Transit.
Symptom
The PDU is in Stop Mode and the EMO Reset Will Not Work See Long Description Sometimes when you push the green EMO reset button on the PDU nothing happens. You cannot hear the 24VDC relay click on nor hear any fans start up. In addition, you keep getting an error message that the PDU is in stop mode or the 24VDC supply has failed after you reset the TPS and attempt to scan.
Error message
2248602 PDU in Stop Mode. Emergency Stop button was pressed or PDU 24 Volt supply has failed. 2248602 PDU is in Stop mode. Emergency Stop button was pressed or PDU 24 Volt supply has failed.
Applies to
- Models
- Signa
- Product
- Signa LX Signa LX Product can be used with 8.x and 9.x systems.
- Software
- 9.1 For Signa LX product only
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.