GE Healthcare · Nuclear Medicine
After PM calibration system fails to update, the PM values listed are from the previous calibration that did pass.
Symptom
After PM calibration system fails to update, the PM values listed are from the previous calibration that did pass. The new values were not saved into the table. After DS Camera PM calibration system fails to update, the PM values listed are from the previous calibration that did pass. The new values were not being saved into the table. After PM calibration system fails to update, the PM values listed are from the previous calibration that did pass. The new values were not saved into the table.
Applies to
- Product
- SMV DS Camera SMV DS Camera SMV DS Camera
- Component
- *Detector (Imaging Detector) *Detector (Imaging Detector) *Detector (Imaging Detector)
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Need part numbers for the Millennium MG/MC table E-Stop