GE Healthcare · X-ray R&F
Proteus OTS Locks Function Erratically when the UIF Detent Switch is Actuated
Symptom
The Proteus OTS locks work erratically when the UIF Detent Switch is actuated. Vertical Lock is locked continually when the Detent switch is actuated. When the Detent Switch is Pushed In, all locks work normally and will detent normally except the Vertical Lock. It stays locked continually & will not release or detent. When the OTS vertical Detent Switch is not actuated, i.e., is released, all locks work normally to table or Chest Stand.
Applies to
- Product
- PROTEUS XRa
- Component
- OTS
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug