GE Healthcare · MRSigna2225687
Will Not Scan With Patient Comfort Sensor Trip.
Symptom
Will Not Scan With Patient Comfort Sensor Trip. See Long Description Patient comfort sensor trip; cannot scan due to bore sensor indicating temperature is too hot for patient safety. A message "Patient Comfort Sensor Trip" appears in the message box on the left side of the scan page at the start of autoprescan.
Error message
2225687 Hardware Failure: The Bore Temperature Reading is invalid. It is Reading too High. Wed Oct 9 14:49:34 2002 Error: 2225687 Host: MCW-MR2 Process: NSP File: HPC_PORT_ID:spi_bore_wall_temp_mon Line: 400 Hardware Failure: the bore temperature reading is invalid. It is reading too high. Check for an open in the sensor, sensor cable, or connector, or a problem with the amplifier board on the SRI.
Applies to
- Models
- Signa
- Product
- Signa LX Signa LX Product can be used with 8.x and 9.x systems.
- Software
- 9.1 For Signa LX product only
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.