GE Healthcare · X-ray R&FDefinium
Flexi DT Table by Suinsa will not charge the batteries due to an overcurrent condition.
Symptom
Flexi DT table will not charge batteries. Power supply measures 28Vdc at Charge Board when unconnected. Power supply measures 7Vdc when connected to Charge Board.
Applies to
- Models
- Definium
- Product
- Flexi DT Table from Suinsa Definium 8000
- Component
- Flexi DT Table – Battery Set Flexi DT Table – Battery Set ACERS0014195 Flexi DT Table - Power Supply with Cable Flexi DT Table – Power Supply w/Cable ACERS0015659 Flexi DT Table – Charge Circuit Board Flexi DT Table – Charge Pcb ACERS0009019
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.