GE Healthcare · MRSigna2225024
Can not scan due to CPD Dip Switch settings improperly set.
Symptom
After Replacing CPD Board System cannot Scan with Power Monitor Firmware Errors
Error message
2225024 The SPI has reported the power monitor firmware version is not compatible "The SPI has reported the power monitor firmware version is not compatible. (.5T vs 1.0T vs 1.5T) Check for correct PowerMonType in MRconfig.cfg file, then verify correct power monitor firmware."
Applies to
- Models
- Signa
- Product
- Signa LX Signa LX Product can be used with 8.x and 9.x systems.
- Software
- 9.1 For Signa LX product only
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.