GE Healthcare · X-ray R&F10737
Prestige VH and II lat table top drive stops before the end stop.
Symptom
Prestige VH and II lat table top drive stops before the end stop. FMI 10737 Table top stops before reaching the end stop. After the first generation of tables this drive board was changed to an on off board. A few of the tables have experienced intermittently table top drive would stop in the middle of the travel. Checking mechanical alignment of the bearings for binding or bad bearings usuall did not reveal the cause.
Applies to
- Product
- Prestige VH
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug