Prestige VH - Grid does not oscillate.
Symptom
Prestige VH - Grid does not oscillate.Drives into stop. At system power up, grid drives to park position, returns to center position, stops as normal. Grid drive responds normally when commanded to drive to park or drive to the center position. Problem is when the grid is commanded to oscillate. Grid starts at center position. Instead of driving back to the park position for 70 msec.it drives forward into the mechanical stop. Monitoring Grid in field position switch signal LED D240, when grid was driven from park to center, LED blinks on then off.
Applies to
- Product
- Prestige VH
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug