GE Healthcare · X-ray R&F
Prestige VH Table drives slow and error W18 and or C17E0 error.
Symptom
Prestige VH Table drives slow with error W18 and or C17E0 error. Table drives slow and error W18 and or C17E0 error. Power Validation ON with no drive command signal. The Prestige VH uses a dual fail safe design requiring 2 signals present to have a table servo drive to move. 2 signals are required to produce the POWER VALIDATION signal. The 2 signals are BP VALIDATION and a drive command signal from either console.
Error message
Error C17E0 Error W18
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug