Millennium AUI system freezing during manual stop and resume on Static PST Flow IMMED scan Currently it has be…
Millennium AUI system freezing during manual stop and resume on Static PST Flow IMMED scan
Symptom
Millennium AUI system freezing during manual stop and resume on Static PST Flow IMMED scan Currently it has been experiencing sluggishness and slowdowns when acquiring a 3-phase bone study - static portion of the scan, IMMED PST FLW. If patient moves or for some other reason the operator needs to stop the acquisition then the freeze occurs. When the system displays the message asking the operator to Quit, Camera On, Resume, or Store, then the system hangs for about 3 minutes. If you leave it alone it finally accepts the chosen command.
Applies to
- Models
- Millennium
- Product
- MPR/MPS Millennium MPR Millennium MPS MG/MC/Myosight Millennium MG/MC Millennium MyoSIGHT
- Software
- GenieAcq R4.5 V14 (M4) Genieacq 4.5 Build 14 (M4) 5220379 Genieacq SW R4.5 V014 M4 with accumulative patches GA450-05-1, GA450-6-1, GA450-07-0, GA450-08-1, and GA450-09-0 for Spare Part GENIE Acq R 4.5 V014 supports EDI and I/N board hardware configurations. The following computer platforms are supported by this version: SuperMicro P4SBR ( only supports the EDI detctor, reference SN43628 ) IBM x205 Dell 1400SC Dell GX200 Dell 1300. Dell 2200 and Intel AltServer are not supported. Reference CIS 5150522-100_r2
- Component
- *Software Software Software
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Need part numbers for the Millennium MG/MC table E-Stop
- How do I Delete a file on Genieacq that the system thinks is still acquiring
- VG, the contour works... but in the opposite way.
- MG_MC_MyoSight_MPR_MPS Bar Phantom Resolution Size