GE Healthcare · X-ray R&F
Prestige VH - JACK 1 Plastic spacers are grinding away.
Symptom
Prestige VH - JACK 1 Plastic spacers are grinding away. Suspect wrong thickness of spacer used. Jack 1, where the jack connects to the table, has plastic washers. These washers or spacers are grinding away. Suspect the wrong thickness of spacers were used in this system. If the wrong size spacer is used it can cause the jack not to be perpendicular to the table. This can cause friction on the spacers resulting in premature wear.
Applies to
- Product
- Prestige VH
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug