Tomolink - Error 76 at turn on of the tableside control console.
Symptom
Tomolink - Error 76 at turn on of tableside control console. Tomolink displays error 76 at turn on of tableside control console. Replaced tableside control console and error 76 still displayed. FE found if he unplugs J101 on processor board in the positioner cabinet, the error changes to 13, drive unit communication error. This is significant because the power up process of the processor board checks the tableside control communications immediately after it's own PRD's. It then goes out to check the drive unit and fulcrum communications.
Error message
Tomolink Error 76 Tomolink Error E13 - Drive Unit Analog Preamp Failure
Applies to
- Component
- Tomolink
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug