GE Healthcare · X-ray R&F
Compax 40E No Autocollimation to the Table Bucky Unless Tomolink is Turned On.
Symptom
Compax 40E No Autocollimation to the Table Bucky Unless Tomolink is Turned On. No autocollimation to the table bucky unless the Tomo mode is selected at the Tomolink control. If the Tomolink is turned off you will get no autocollimation to the table bucky but you will get autocollimation to the chest stand.
Applies to
- Component
- Compax 400T
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug