GE Healthcare · X-ray R&F
Compax40E - Service Note 4106A Fragile Bucky Handle Mounting
Symptom
Compax40E - Service Note 4106A Bucky Handle Mounting is to Fragile. 1. For all Compax tables, the Bucky Handle is too fragile and is easily broken. 2. The former Bucky Handle used for all Compax 40E is not compatible with the wiring for the Compax 40E (no CE). For the Bucky Handle of the Compax 40E (no CE) the enable push-button switch is in an open configuration different from the close configuration of the Compax 40E (CE). 3. Some Bucky Handle are not delivered with the minimum screw length. This causes the Handle to break easily.
Applies to
- Component
- Compax 400T
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug