GE Healthcare · X-ray R&F
Fuji CRAC3 CRAC3CS CRAC3CSID CR9000 CR9501
Symptom
Fuji CRAC3 CRAC3CS CRAC3CSID CR9000 CR9501: Power supply AC supply input voltage config. On Fuji units the power supply can be configured for 100, 116, 230 or 240 AC input voltage depending on the site. The power supply is configured by a jumper plug that plugs into CN4 of the power supply. The instructions or schematic for each configuration of the plug are not very easy to find in the Fuji service manual.
Applies to
- Component
- FUJI
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug