Fuji CRAC3CS, CRAC3, CR9000, CR9501 with ACRQA 1.0 or 2.0
Symptom
Fuji CRAC3CS, CRAC3, CR9000, CR9501 with ACRQA 1.0 or 2.0: Reader doesn't read image plate, no errors. Image plate stops right before the reader starts scanning it. No errors or alarms. The HIC icon in the IDT is always on (highlited). Fuji system never acknowledges when ACRQA has full disk. If ACRQA fills up, the disk with images will stop receiving images from CR, Fuji Cr doesn't give an alarm or warning to operator, HIC icon stays lit, like normal operation. If image plate is run thru Fuji reader under these conditions, reader will take the plate and leave at entrance of scanner process.
Applies to
- Component
- FUJI
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug