GE Healthcare · X-ray R&F
Fuji CRAC3 not transmitting images to Amber CRQA due to misplaced cable.
Symptom
Fuji CRAC3 not transmitting images to Amber CRQA. After the AC-3 reads the image plate, it starts sending the data to the Amber (you can tell by looking at the DASM led activity). The Amber has a message that is receiving an image. After about 5 minutes the AC-3 times out and spits out an error message. The Amber keeps saying "receiving image" until is rebooted.
Applies to
- Component
- FUJI
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug