GE Healthcare · X-ray R&FPrecisionRevolution
P500D Information for CAN termination jumpers for systems without an OTS or Wallstand.
Precision 500D Aurora Non-OTS CAN Bus Termination
Symptom
P500D Information for CAN termination jumpers for systems without an OTS or Wallstand.
Applies to
- Models
- Precision, Revolution
- Product
- Precision 500D Revolution XRd2X
- Software
- Aretha M5 IUI software release 11.xx upgrade to Odetta IUI software rel. 13.xx. Odetta
- Component
- Wallstand (Revolution XR/d 2X) Wallstand (Revolution XR/d 2X) OTS
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.