GE Healthcare · MRSigna2244577

Scan Stopped With Corduroy Artifact and Vertical Lines and Bands with Y-Axis Current distortion Fault due to Wide Area P…

Scan Stopped With Corduroy Artifact and Vertical Lines and Bands with Y-Axis Current distortion Fault due to Wide Area Power Event.

Symptom

MRIQ Corduroy Artifact with Vertical Bands & Lines and "Y-Axis Current Distortion Fault" Error See long Description Customer was scanning when the scan stopped and image artifacts were found to have occurred that showed bright white vertical bands and lines and a corduroy effect in the images. See Attachment for an example of one of these images. The error shown below was found to have been logged several times at the time of this event: (PQR 13089479) 2244577 The GP reported a Z Axis Current Distortion Fault. If no other faults occurred, check LCoil Calibration. Else, run Gradient Driver Tests to isolate the FRU. If Tests pass, see Troubleshooting Manual.

Error message

2244577 The GP reported a % Axis Current Distortion Fault 2244577 "The GP reported a Z Axis Current Distortion Fault. If no other faults occurred, check LCoil Calibration. Else, run Gradient Driver Tests to isolate the FRU. If Tests pass, see Troubleshooting Manual."

Applies to

Models
Signa
Product
Signa LX Signa LX Product can be used with 8.x and 9.x systems.
Software
9.1 For Signa LX product only
Area
MR

Full cause & step-by-step resolution

The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.

Start free trialSign in

7-day free trial · no credit card required

Related GE Healthcare MR issues