GE Healthcare · X-ray R&F
Prestilix SN 3203 INFORMATION FOR PRESTLIX 1690 AND 1690S
Symptom
Prestilix SN 3203 INFORMATION FOR PRESTLIX 1690 AND 1690S Refer to attached GE-CGR Service Note SN 3203: RX.89.0006 for information on the following Prestilix 1690 and 1690S topics: A. Damage to thyristors S101DH. B. Introduction of myelography kit. C. New shade (new co lor of mist gray). D. Light centering device fuse. E. Improvement of rack stop precision.
Applies to
- Product
- Prestilix
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug