GE Healthcare · X-ray R&F
Bennett Silhouette SE - Errors
Symptom
Bennett Silhouette SE - Errors: SES 410 and KVP - C ERROR "SES 410" still happens after the replacement of new Source Board (P/N: 2132436). Found 1. Fuse F1 (1.5 A) blown. 2. R32 (2 Ohm-5 Watt) open circuit. 3. R3 (200 ohm-25 Watt) open circuit. 4. Diode D10 (1N4005) short circuit.
Error message
KVP-C Error KVP-C Error SES 410 Error
Applies to
- Product
- Silhouette HF
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug