GE Healthcare · X-ray R&F21274162132460
Bennett Silhouette HF Three Phase Generator Bridge Rectifier BR1 and BR2 - Correct part number?
Symptom
Bennett Silhouette HF - Correct part number for Three Phase Generator Bridge Rectifier BR1 and BR2. The part number shown in direction 2127416-100 Silhouette HF Service Manual, for Bridge Rectifiers BR1 and BR2 is shown as 2132460. This is the wrong part number and corresponds to the part number used in the SE or Single Phase units.
Applies to
- Product
- Silhouette HF
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Bennett Silhouette HF There is a mistake on "Line Voltage Monitor Calibration P/N 208099, section 2-6, step 3 on Silhouette S.M.
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.