GE Healthcare · X-ray R&F
Bennett Silhouette SES 410 Error at Boot Up
Symptom
Silhouette SES 410 Error at Boot-Up SES error indicates "Stored Energy System" (battery voltage is out of spec) Can be caused by; Battery voltage too low or too high. (410 VDC +- 10%) The two banks of batteries associated with one source charger board are out of balance. (couldn't find spec) Or one bank out of spec. (nominally 204 to 206 VDC) Sense circuit adjust is out of cal.
Error message
SES 410 Error
Applies to
- Product
- Silhouette HF
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug