GE Healthcare · X-ray R&FDefiniumRevolution
Def8000, XRd2X Chiller came with no housing fan installed, and Detector would overheat if left with cover on c…
Definium 8000 and Revolution XRd2X (Lightning) Conditioner Problem, fan removal Service Note 35031
Symptom
Def8000, XRd2X Chiller came with no housing fan installed, and Detector would overheat if left with cover on chiller. Took cover off and it was okay.
Applies to
- Models
- Definium, Revolution
- Product
- Definium 8000 Revolution XRd2X
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- Revolution XR/d After a Load From Cold, the AWS exhibits strange operation and the SUIF does not have any Positioner Configuration and Calibration selections due to the use of the incorrect Jumpstart…
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.