GE Healthcare · X-ray R&FDefinium1090454
Def8000 120 vac going into the Wallstand Power Supply but no 24 VDC came out.
Definium 8000 Thunder Wallstand Power Supply
Symptom
Def8000 120 vac going into the Wallstand Power Supply but no 24 VDC came out. What is the part number? Is there a FRU list of additional FRU's beyond what the renewal parts show? Is it possibly a Astec LPS155? Is the power supply bad? Was the 24VDC disconnected from the Wallstand I/O Board when the supply output was checked?
Error message
Error 2903,"VEN",1090454, A WS CAN Command was not processed successfully.,2222,WR,DEFAULT, Pos, DeviceGroup, Retry or reset the system,1,1,1, ThunderWSDevice CAN Command ERROR,../DeviceGroup/ThunderWSDevice/ThunderWSDevice.cpp,1176.
Applies to
- Models
- Definium
- Product
- Definium 8000
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.