AMX 700 System cannot prep after a cancelled exposure attempt
Symptom
Definium AMX 700 If the user pressed the hand switch to take an exposure, but released the hand switch before x-rays were generated, the system might post a “Wait for raw image” inhibit even though there was no exposure taken. If the user pressed the hand switch to take an exposure, but released the hand switch before x-rays were generated, the system might post a “Wait for raw image” inhibit even though there was no exposure taken.This inhibit would be displayed for about 10 seconds. On some cases, a generator error could be seen in the error log.
Applies to
- Models
- Definium
- Product
- Definium AMX 700
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.