GE Healthcare · X-ray R&FDefinium
Def8000 If the tube warm-up function is invoked from the worklist and then exited (with or without completing…
Definium 8000 Wallstand Tracking After a Tube Warm-up May Cause Confusion
Symptom
Def8000 If the tube warm-up function is invoked from the worklist and then exited (with or without completing the warm-up), the positioner still is in a tube warm-up offset mode. If an operator then does an auto position to the wallstand, the OTS will align offset to the detector. Another manifestation is that the operator may reposition the wallstand detector but the OTS will track with an offset giving the impression that there is an alignment problem.
Applies to
- Models
- Definium
- Product
- Definium 8000
- Component
- Wallstand (Thunder)
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.