GE Healthcare · X-ray R&FDefinium
Def8000 When Auto Positioning to any 100 or 180 cm SID selection, the system will move exactly to 100 or 180 c…
Definium 8000 Auto Positioning
Symptom
Def8000 When Auto Positioning to any 100 or 180 cm SID selection, the system will move exactly to 100 or 180 cm SID. If the detents are configured at a different SID, the OTS will not be at the detent at the conclusion of its moveThis will be especially noticeable at English unit sites that have detents programmed at 40in and 72in that are 102 and 183 cm respectively.
Applies to
- Models
- Definium
- Product
- Definium 8000
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.