GE Healthcare · X-ray R&FRevolutionDefinium
Def8000, AMX700, XRd2X Customer worklist is long (over 600 entries) and the refresh time is too short causing…
Definium 8000, AMX700, Revolution XRd2X Worklist causes start exam lockups
Symptom
Def8000, AMX700, XRd2X Customer worklist is long (over 600 entries) and the refresh time is too short causing Start Exam Failure.
Applies to
- Models
- Revolution, Definium
- Product
- Revolution XRd2X Definium AMX 700 Definium 8000
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- Revolution XR/d After a Load From Cold, the AWS exhibits strange operation and the SUIF does not have any Positioner Configuration and Calibration selections due to the use of the incorrect Jumpstart…
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.