GE Healthcare · MRSigna
Replaced bad I or Q heliax cable leading to the body coil
Symptom
Arcing Heliax cable One of the blue 1/2 wavelength I and Q Heliax cables connected from the body hybrid to the body coil was bad. When they disconnected it, the center pin stuck in the hybrid splitter. They found on examining it that it had been arcing.
Error message
Spurious DD/TR Driver Fault
Applies to
- Models
- Signa
- Product
- Signa LX Signa LX Product can be used with 8.x and 9.x systems.
- Software
- 9.1 For Signa LX product only
- Component
- 46-328147G1 Run 743 RF Cable from Hybrid Splitter J3 to Body RF Coil J2 MG3 A3 A1 J3 to MG2 A12 A1 J2. 10 ft Coax w/M&F “N”. comments: "Body Coil Drive" 46-328147G2 Run 744 RF Cable from Hybrid Splitter J4 to Body RF Coil J1 MG3 A3 A1 J4 to MG2 A12 A1 J1. 10 ft Coax w/M&F “N”. comments: "Body Coil Drive"
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.