When Ventri fails start up test, How can I raise the Ventri table to remove covers, so I can work inside of the table.
Symptom
When Ventri fails start up test, How can I raise the Ventri table to remove covers, so I can work inside of the table. Putting on the dollies to the table and unbolting it from the gantry will take to long. When Ventri fails start up test, How can I raise the Ventri table to remove covers, so I can work inside of the table. Putting the dollies on the table and unbolting it from the gantry will take too long. Scenario: Ventri table is broken in the max down position, gantry will not calibrate, not able to move table up. How do I move the table up for service access if the gantry does not initialize?
Applies to
- Product
- Ventri Ventri Ventri
- Component
- *Patient Table *Patient Table *Patient Table
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Need part numbers for the Millennium MG/MC table E-Stop