GE Healthcare · X-ray R&FRevolutionPrecisionDefinium
Def8000, AMX700, Revolution XRd2X, XRd, Precision 500D Images appear different on PACS than on acquisition wor…
Definium 8000, AMX700, Precision 500D, Revolution XRd2X (Lightning) Image Display on PACS
Symptom
Def8000, AMX700, Revolution XRd2X, XRd, Precision 500D Images appear different on PACS than on acquisition workstation. Images may appear with any number of differences: more contrast, less contrast, saturation in dark or bright areas, etc. The problem is often reported by the radiologist or technologist. The images may have acceptable image quality at the acquisition workstation, but unacceptable at the PACS or review workstation.
Applies to
- Models
- Revolution, Precision, Definium
- Product
- Revolution XRd Revolution XRd2X Precision 500D Definium AMX 700 Definium 8000
- Software
- Revolution XR/d 2X Platform (Lightning) – M4
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.