GE Healthcare · MR22257132225714
cannot scan due to RF errors.
Symptom
Will Not Scan With RF Errors Will not scan with RF errors
Error message
2225713 Power Monitor 1 Fault. RF Transmit Power has Reached Safety Limit Allowed for Scan Parameters and Patient Weight. See long description Thu Apr 15 11:50:18 2004 Error: 2225713 Host: lx-mr Process: NSP File: HPC_PORT_ID:spi_pm_log_error Line: 100 Power Monitor 1 Fault. RF Transmit power has reached safety limit allowed for scan parameters and patient weight. Check patient weight entered. amplitude: 255 pulse width: 07 duty cycle: 02 Fault in head amplitude. If you need to confirm the source of the fault, reset the power monitor and repeat the scan. This could also occur when power cycling SSM. 2225714 Power Monitor 2 Fault. RF Transmit Power has reached Safety limit Allowed for scan Parameters and Patient Weight. See long description Thu Apr 15 11:50:19 2004 Error: 2225714 Host: lx-mr Process: NSP File: HPC_PORT_ID:spi_pm_log_error Line: 100 Power Monitor 2 Fault. RF Transmit power has reached safety limit allowed for scan parameters and patient weight. Check patient weight entered. amplitude: 255 pulse width: 07 duty cycle: 02 Fault in head amplitude. If you need to confirm the source of the fault, reset the power monitor and repeat the scan. This could also occur when powe
Applies to
- Product
- HF OpenSpeed HFO1 HFO2 and HFO3 Only.
- Software
- HFO3
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- RF calibration not in specification.
- RF Transmit Power has reached Safety limit Due to a Defective Head Coil.
- Unable to scan with Power Monitor Faults due to HN Bulkhead Connector or Body Heliax Feed Through Connector.
- Will Not Scan Due to RF Errors
- Will Not Scan Due to RF Errors
- Power Monitor Faults on one series