Defective Octane I System Module Brick OPTION 195MHZ PROCESSOR MODULE.
Symptom
Unable to Boot Octane Computer. Light Bar Immediately goes to Solid Red. No Output to Monitor See Long Description The light bar is never white, it immediately goes to solid red. One of the required LED's on the lower right front of the Octane I chassis was out: The upper right "PCI Chassis" LED was out, so FE replaced the PCI chassis. That LED came on after that but the original symptoms remained. FE replaced the Octane's System Module, Power Supply, & Front plane Module which didn't fix the problem. Initially when the FE installed the new Front plane Module, the light bar went white briefly, but then went red again and the original symptom returned (only red light bar).
Applies to
- Models
- Signa
- Product
- Signa LX Signa LX Product can be used with 8.x and 9.x systems.
- Software
- 9.1 For Signa LX product only
- Component
- 2169940-18 OPTION 195MHZ PROCESSOR MODULE
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.