GE Healthcare · X-ray R&FDefinium
Def8000 During auto positioning, the OTS drives longitudinally about 1-inch and then stops.
Definium 8000 Longitudinal Drive Problem
Symptom
Def8000 During auto positioning, the OTS drives longitudinally about 1-inch and then stops. Longitudinal Drive Assembly has already been replaced with no change.
Error message
Error 1418 OTS Longitudinal Amplifier position Error 1421 Error 1419 OTS Longitudinal Amplifier Tracking Error 1423 Error 1417 OTS Longitudinal Amplifier tracking warning Error 1422 Auto position move failed Error 1420
Applies to
- Models
- Definium
- Product
- Definium 8000
- Component
- OTS
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.