GE Healthcare · X-ray R&FDefinium800201400011520001480004034000053400013
Def8000 Users reported they received a "Protocol not available" message and the protocol screen would not fill…
Definium 8000 Protocol Issue - Multiple Error Codes
Symptom
Def8000 Users reported they received a "Protocol not available" message and the protocol screen would not fill in. They reset the system and did a complete shutdown and reboot with no change in the symptoms.
Error message
Error 4148 "VEN",800201, Network is Down.Queuing the jobs.,2222,WR,DEFAULT, XRDataMgr, network, None.,1,1,1,(null),RALSession.cpp,375 Error 4151 "VEN",400011, Time out.,2222,WR,DEFAULT, SysCntrl, control, Software problem,1,1,2, Time out while in CLEAR_OPMODES waiting for XRImDet XRTechOpt XRAcqSync XROpDesc ,XRAppDirSM.cpp,904 Error 4150 "VEN",5200014,"OpMode Configuration failed, please try select protocol again.",2222,DO,DEFAULT, IUI, APPSETUP,"Select protocols again, Reset if problem persists",1,0,2,(null),XRUserIfActor.cpp,959 Error 4147 "VEN",800040, Network push failed. Failed to communicate with remote host,2222,WR,DEFAULT, XRDataMgr, network Error 4155 "XRS",3400005, The system is booting.,2222,DO,DEFAULT, SysCntrl, Control, computer,1,1,1,(null),XRSysMgr.cpp,179 Error 4149 "VEN",800040, Network push failed. Failed to communicate with remote host,2222,WR,DEFAULT, XRDataMgr, network, Check remote node configuration. Check if the remote node is connected to network. Run Ethernet diagnostics. ,1,1,1,(null),TerraJobCa Error 4152 "VEN",5200014,"OpMode Configuration failed, please try select protocol again.",2222,DO,DEFAULT, IUI, APPSETUP,"Select protocols again, Reset if
Applies to
- Models
- Definium
- Product
- Definium 8000
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.