GE Healthcare · X-ray R&FDefiniumRevolution51808302332506
Def8000 New replacement parts kit (Part Number 5180830) has been created for the "Grid In" and "QAP In" sensor…
Definium 8000 Table Detector Grid Sensor Replacement
Symptom
Def8000 New replacement parts kit (Part Number 5180830) has been created for the "Grid In" and "QAP In" sensors used on the table receptor housing. The original part number 2332506 slot-type sensor assembly is no longer available; it has been replaced by reflective-type sensors.
Applies to
- Models
- Definium, Revolution
- Product
- Definium 8000 Revolution XRd Gipeto Version Revolution XRd2X
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- Revolution XR/d After a Load From Cold, the AWS exhibits strange operation and the SUIF does not have any Positioner Configuration and Calibration selections due to the use of the incorrect Jumpstart…
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.